Professional VMware NSX-T Data Center 2V0-41.20 real exam questions have been updated, which are helpful for you to prepare this 2V0-41.20 exam and earn VMware VCP-NV 2021 certification. We all know that VMware certification 2V0-41.20 exam validates an individual can install, configure, setup, maintain, and perform basic troubleshooting of software-defined networks based on VMware’s NSX-T 3.0 Data Center. Study the following VMware 2V0-41.20 exam information to prepare this 2V0-41.20 test.
VMware VCP-NV 2021 2V0-41.20 Exam
The Professional VMware NSX-T Data Center 3.0 exam 2V0-41.20 which leads to VMware Certified Professional–Network Virtualization 2021 certification is a 70-item exam, with a passing score of 300 using a scaled method. Candidates are given an appointment time of 130 minutes, which includes an adequate time to complete the exam for non-native English speakers. Candidates can register VMware VCP-NV 2021 2V0-41.20 exam at Pearson VUE test center.
VMware 2V0-41.20 Exam Objectives
VMware 2V0-41.20 exam objectives cover the following sections.
Study Updated 2V0-41.20 Real Exam Questions
VMware certification 2V0-41.20 real exam questions updated version can help you test all the above Professional VMware NSX-T Data Center 2V0-41.20 exam objectives. Share some updated VMware VCP-NV 2021 2V0-41.20 real exam questions below.
1.Which discovery protocol is supported for hypervisor transport nodes?
A. Adobe Real-time CDP
B. Neighbor Discovery Protocol
C. Cisco Discovery Protocol
D. Link Layer Discovery Protocol
Answer: D
2.An administrator has a requirement to have consistent policy configuration and enforcement across NSXT instances.What feature of NSX-T Data Center fulfills this requirement?
A. Load balancer
B. Policy-driven configuration
C. Multi-hypervisor support
D. Federation
Answer: B
3.Which CLI command is used to disable SSH timeout on NSX Manger and NSX Edge nodes?
A. set cli ssh timeout 0
B. set esxcli ssh session off
C. set cli-timeout 0
D. nsxcli ssh session on
Answer: C
4.Which tool could be used to configure BGP on a Tier-0 Gateway?
A. PowerShell
B. API
C. ESX CLI
D. NSX CLI
Answer: D
5.When running nsxcli on an ESXi host, which command will show the Replication mode?
A. get logical-switch <Local-Switch-UUID> status
B. get logical-switch <Logical-Switch-UUID>
C. get logical-switches
D. get logical-switch status
Answer: B
