NetApp Certified Implementation Engineer-SAN, ONTAP NS0-520 real exam questions have been updated, which contain 334 Q&As. To take Netapp certification NS0-520 exam, you need to pass NS0-162 exam and earn NCDA ONTAP certification first. NCIE-SAN Specialist, ONTAP certification can prove your skills planning, implementing, integrating, and troubleshooting ONTAP SAN, FC switched fabrics and Ethernet iSCSI/FCoE solutions, and different operating systems and applications.
Netapp NS0-520 Exam
Network Appliance NS0-520 exam information is a first step for you to learn the test. There are 60 questoins in real NetApp Certified Implementation Engineer-SAN, ONTAP NS0-520 exam, and you have 1-1/2 hours to complete all the questions. In countries where English is not the native language, candidates for whom English is not their first language will be granted a 30-minute extension to the allotted examination completion time. You can register Netapp certification NS0-520 exam at Pearson VUE test center.
NS0-520 Netapp Certification Exam Topics
Netapp Certification NS0-520 exam topics cover the following details.
Share Updated NS0-520 Real Exam Questions
To test all the above Netapp certification NS0-520 exam topics, the new updated NetApp Certified Implementation Engineer-SAN, ONTAP NS0-520 real exam questions are the best material. Share some updated Netapp NS0-520 real exam questions and answers below.
1.Which option of the snap restore command allows you to specify a different directory, as long as the directory already exists?
A. snap restore -c
B. snap restore -d
C. snap restore -r
D. snap restore s
Answer: C
2.You are planning to set up a new SAN with an AFF A300 2-node switchless cluster. Your SAN fabric will consist of Cisco MDS9148s switches. According to NetApp best practices, which two actions would be required to accomplish this task? (Choose two.)
A. Set the switchport speed setting to 16 GB.
B. Use single initiator, multiple target zoning.
C. Use multiple initiator, single target zoning.
D. Set the switchport speed to auto negotiate.
Answer: BD
3.When will a Volume SnapMirror (VSM) from a 64-bit source to a 32-bit destination volume fail?
A. When the 64-bit volumes has Volume Guarantee disabled
B. When the 64-bit volume has compression enabled
C. When the 64-bit volume has FlexShare enabled
D. When the 64-bit volume has ASIS enabled
Answer: B
4.Which command can you use to determine the state of the FC ports for a Brocade switch?
A. switchreveal
B. switchview
C. switchshow
D. switchstatus
E. switchstate
Answer: C
5.You create a new iSCSI SVM and secure iSCSI sessions by using both Challenge-Handshake Authentication Protocol (CHAP) and iSCSI Access Control Lists (ACL). In this scenario, in which two ways are you securing your iSCSI implementation? (Choose two.)
A. CHAP creates a hash value for the username and shared secret.
B. iSCSI ACLs are applied to the initiator configuration to provide an IP address of the targets.
C. CHAP encrypts all iSCSI session I/O.
D. iSCSI ACLs are applied to the target configuration to provide an IP address of the initiators.
Answer: AD
