Shop Categories

 [email protected]
Search
View Cart
Checkout

The following NS0-184 questions are part of our Network Appliance NS0-184 real exam questions full version. There are 371 in our NS0-184 full version. All of our NS0-184 real exam questions can guarantee you success in the first attempt. If you fail NS0-184 exam with our Network Appliance NS0-184 real exam questions, you will get full payment fee refund. Want to practice and study full verion of NS0-184 real exam questions? Go now!

 Get NS0-184 Full Version

Network Appliance NS0-184 Exam Actual Questions

The questions for NS0-184 were last updated on Feb 21,2025 .

Viewing page 1 out of 4 pages.

Viewing questions 1 out of 20 questions

Question#1

What is the main function of ACP?

A. it allows cabling the shelf to two additional controllers.
B. It allows the controller to use Ethernet instead of SAS to fetch the storage data.
C. it allows the controller to nondisruptively reset the SAS expanders.
D. It enables the automatic shelf ID assignment.

Question#2

When you start a new Service Event Report, what must be entered first?

A. the case ID number
B. the project number
C. the node serial number
D. the sales order number

Question#3

A new AFF8200 has a four-port UTA2 adapter installed in slot 2. Using the ucadmin command, you see that these ports are configured for FC.
Which port names are correct in this scenario?

A. e0a/0a, e0b/0b, e0c/0c, e0d/od
B. e2a/2a, e2b/2b, e2c/2c, e2d/2d
C. e2a, e2b, e2c, e2d
D. 2a, 2b, 2c, 2d

Question#4

Click the Exhibit button.



You are asked to install a new cluster with six FAS8060 nodes. While running Config Advisor, you see the messages shown in the exhibit. The customer does not want ACP cabled on their cluster.
Which two actions would allow the installation to be completed successfully? (Choose two.)

A. Advise NGS that the customer has a controller in an unsupported state.
B. Advise the customer that they must acknowledge that they are not using ACP on the installation.
C. Advise the sales team that the customer is operating without ACP and that the customer is asking you to leave it that way.
D. Advise the customer that the error will cause the controller to not operate properly and create an unsupported state.

Question#5

An iSCSI LIF fails to migrate during a storage failover test. In this scenario, why did the LIF not migrate?

A. A failover port was not defined
B. LIFs that serve block protocols do not failover
C. The failover policy was not configured
D. LIF failover was not enabled

Exam Code: NS0-184Q & A: 371 Q&AsUpdated:  Feb 21,2025

 Get NS0-184 Full Version
 About NS0-184 Questions

TOP Exams