The following
300-615
questions are part of our
Cisco
300-615
real exam questions full version. There are
168
in our
300-615
full version. All of our
300-615
real exam questions can guarantee you success in the first attempt. If you fail
300-615
exam with our
Cisco
300-615
real exam questions, you will get full payment fee refund. Want to practice and
study full verion of
300-615
real exam questions? Go now!
Get
300-615
Full Version
Cisco 300-615 Exam Actual Questions
The questions for 300-615 were last updated on
Feb 21,2025
.
Viewing page 1 out of 4 pages.
Viewing questions 1 out of 20 questions
Question#1
Refer to the exhibit.
An OSPF adjacency between Router-A and Router-B cannot reach the FULL state .
Which action resolves the issue?
A. Adjust the MTU on Router-A to 1600.
B. Disable the check of the MTU value.
C. Set the OSPF media type to point-to-point.
D. Adjust the MTU on Router-B to 1604.
Question#2
A Cisco UCSB-Series Blade Server is configured to boot a VMwareESXi host from an EMC VNX storage array by using a Fibre Channel SAN. The boot order is confirmed to be configured as expected but the server fails to boot from the SAN .
Which action reserves the problem?
A. Set the same WWPN pools for vHBA adapters
B. Set the boot LUN to the highest LUN ID in the storage array
C. Set the boot LUN to the lowest LUN ID in the storage array
D. Set the same WWNN pools for vHBA adaptor
Question#3
A request to activate the port security database is rejected .
Which action do you perform to investigate the cause of the issue?
A. Enable the auto-learning feature.
B. Use the force option to identify rejected devices.
C. Find conflicting entries between the active and configuration databases.
D. Verify that devices are fully attached to the active database.
Question#4
An engineer removes a VMM domain from an endpoint group called EPG-1, but the distributed port group fails to be deleted .
Which action must be taken to resolve the issue?
A. Remove the port group manually.
B. Migrate all virtual machines in the EPG-1 to different hypervisors.
C. Remove the remaining EPGs from the VMM domain.
D. Migrate all virtual machines in the EPG-1 to different port groups.
Question#5
An upgrade of protected RPMs from the Bash shell did not take effect .
Which action is required for the changes to take effect?
A. Restart the Bash shell.
B. Reload the switch.
C. Upgrade the RPMs from the Guest shell.
D. Disable and reenable the Bash feature.
