Shop Categories

 [email protected]
Search
View Cart
Checkout

The following 300-510 questions are part of our Cisco 300-510 real exam questions full version. There are 214 in our 300-510 full version. All of our 300-510 real exam questions can guarantee you success in the first attempt. If you fail 300-510 exam with our Cisco 300-510 real exam questions, you will get full payment fee refund. Want to practice and study full verion of 300-510 real exam questions? Go now!

 Get 300-510 Full Version

Cisco 300-510 Exam Actual Questions

The questions for 300-510 were last updated on Feb 21,2025 .

Viewing page 1 out of 4 pages.

Viewing questions 1 out of 20 questions

Question#1

What is the difference between a source tree and a shared tree in a multicast environment?

A. To route traffic from source to receiver a source tree uses a link-state routing protocol and a shared tree uses a distance-vector routing protocol.
B. A source tree has its root at the source, and a shared tree has its root at a designated rendezvous point.
C. To stream multicast from source to receiver, a source tree uses PIM-SM and a shared tree uses PIM-D
D. Source trees are the default type for bidirectional PI
E. and PIM-DM uses shared trees by default.

Explanation:
Reference: https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/ipmulti_pim/configuration/xe-16-5/imc-pim-xe-16-5-book/imc-tech-oview.html

Question#2

Refer to the exhibits.



A network operator is troubleshooting packet loss seen from the R1 loopback interface to the R2 loopback interface over the core network. The operator is attempting to identify the next leg in the path from PE1 .
Which interface and label path should the operator investigate next?

A. PE1 C Gi0/0/0/3 - forwarding label 24002
B. PE1 C Gi0/0/0/2 - forwarding label 24002
C. PE1 C Gi0/0/0/3 - forwarding label 24001
D. PE1 - Gi0/0/0/2 - forwarding label 24001

Question#3

Refer to the exhibit.



When implementing SRv6, which SID does R2 propagate into area 0 for the prefix 2001:DB8:1:1/128?

A. 120
B. 230
C. 110
D. 10

Question#4

Refer to the exhibit.



An administrator is troubleshooting Internet access issues on a customer’s network. After applying this ISIS configuration to R1, the administrator notices that it fails to redistribute the default route into IS-IS. After checking the connectivity between the ISIS router and the ISP router the engineer confirmed there is Layer 3 connectivity between them.
Which action should be taken to correct the problem?

A. Associate the default route with a VRF
B. Add the default-information originate command to the configuration
C. Configure the default route under any routing protocol other than IS-IS
D. Configure R1 as a Layer 1 router

Question#5

You have configured MSDP peering between two autonomous systems that pass traffic between two sites, but the peering has failed to come up.
Which task do you perform to begin troubleshooting the problem?

A. Verify that multicast has been disabled globally
B. Verify that PIM-DM is configured on the source interface
C. Verify that both source interfaces are reachable from both peers
D. Verify that the two MSDP peers allow asymmetric routing

Exam Code: 300-510Q & A: 214 Q&AsUpdated:  Feb 21,2025

 Get 300-510 Full Version
 About 300-510 Questions

TOP Exams